DXGE interface

The SFP+ {{glossary.10 GigE}} connectors permit to use (direct attach) copper cables or optical fiber cables with lengths of up to 400 m (10GBASE-SR).

Use a single port for data rates up to 10 Gbit/s.
For higher data rates connect both ports using Link Aggregation.

Network adapter

To establish a {{glossary.DXGE}} connection a network adapter with one or two SFP+ {{glossary.10 GigE}} inputs must be installed and configured on the PC. The installation of a network adapter is explained in the GCT documentation. For more information, see Installation GigE.

For more information about the tested network adapters and the transceivers, see Tested Network adapters and Transceivers.

Cabling

Connect one or both video output ports.
Connect the digital I/O port.
Connect the power supply.

CXP interface

The interface allows you to connect up to four {{glossary.CXP}} cables. Micro BNC (for CXP12) connectors for the camera and suitable connectors for the frame grabber are required. The maximum cable length is 35 m.

Frame grabber

To establish a {{glossary.CXP}} connection a frame grabber must be installed and configured on the PC. Refer to the manual of your frame grabber.

For more information about the tested frame grabbers, see Tested frame grabbers.

Cabling

Connect port 0 (master port) of the video output port.
NOTE
For the maximum line rate connect all four ports.
Make sure that port 0 of the camera is connected to port 0 (or A) of the frame grabber. Otherwise, no connection to the camera can be established.
Connect the digital I/O port.

Option 1: Power over CoaXPress (PoC)

To use the power-over-{{glossary.CXP}} function two connections are needed.

Connect port 0 and port 1 of the video output port.

Option 2: Power supply port

Connect the power supply.

Digital I/O port

LVCMOS and RS422 levels

Circuit Diagrams

RS422 configuration

Single-Ended configuration

Power supply

pin	name
1	TX+
2	TX–
3	RX+
4
5
6	RX–
7
8

function	setting
IP address	static
IP adress	192.168.87.234

X3 Ethernet port

Default settings