Flash operating mode
- 04 Jul 2024
- 1 Minute to read
- Print
- PDF
Flash operating mode
- Updated on 04 Jul 2024
- 1 Minute to read
- Print
- PDF
Article summary
Did you find this summary helpful?
Thank you for your feedback
The Flash operating mode is used for flash operation. For example the light is switched on for every single scanned object.
XLC4-1 (CP000411)
The following parameters can be adjusted:
Parameter | Description | Min | Nominal | Max | Unit |
|---|---|---|---|---|---|
Flash frequency | 1 | 10 | 20 | kHz | |
Trigger pulse | 10 | 20 | µs | ||
ON-Delay | for input voltage 4.5 V | 10 | µs | ||
for input voltage 10 V | 3 | µs | |||
OFF-Delay | for input voltage 4.5 V | 20 | µs | ||
for input voltage 10 V | 60 | µs |
XLC4-1A (CP000411-1A) and XLC4-1F4 (CP000411-1F4)
The following parameters can be adjusted:
Parameter | Description | Min | Nominal | Max | Unit |
|---|---|---|---|---|---|
Flash frequency | 1 | 60 | kHz | ||
Trigger pulse | 10 | tP – 2 | µs | ||
ON-Delay | 0.6 | µs | |||
OFF-Delay | for input voltage 4.5 V | 0.6 | µs |
NOTE
Take care about the timing and refer to Chromasens support.
Was this article helpful?